Member name: robert
From: Utard
Photos: robert has not uploaded any photos
Joined: Fri Jan 4 18:36:29 2008
Profile updated: Fri Jan 4 18:36:29 2008
Contact: [please login to contact this member]
robert has posted 0 messages and replied to 5 messages.
| just a guy who makes stuff | List of 100 most recent messages and comments- Sat Jan 5 11:26:56 2008:
OKUMA_LB_25_ALARM_CODE_119 Commentjose luis sola mente tiene que estaruno prendido ala ves. cuando estas cambiando od o id por ejemplo, cuando lo... led se apagara entonses ajusta la luz asta que prenda cuando la luz esta prendida no se prendera la alarma att.robert... - Fri Jan 4 19:37:02 2008:
How_god_is_Haas_machining_centers_for_maching_Steel Commentmike I think personally that Haas makes a very user freindly machine but the puma is probably of a higher rigidity and... think personally that Haas makes a very user freindly machine but the puma is probably of a higher rigidity and quality... - Fri Jan 4 19:24:05 2008:
mdi Commentthere is an interlock button in manual and mdi modes either turrit 1 or turrit 2 needs to be individually highlighted... while pushing the button which designates which turrit you want to manage then you should just be able to say t0202... - Fri Jan 4 19:17:18 2008:
OKUMA_LB_25_ALARM_CODE_119 Commentonly one led can be lit at a time depending on whether you are trying to chuck od or id if you were chucking od and... the light goes on unclamp the chuck the light will go off again at this point you can adjust it until it goes on again ... - Fri Jan 4 19:05:38 2008:
92_VR40_OMP500M_G_Memory Commentokumas are very macro freindly if the problem is too much code you might want to think about writing it so there is... macro freindly if the problem is too much code you might want to think about writing it so there is simply less code...
|
For the full benefit of The CNC Forum website please register and login. You can upload your photos and interact with other users better.
Note: once you register your email address with The CNC Forum it is used across our whole network of forums and blogs. You can create seperate profiles for each forum or blog, but use the same login.
|