bj0629 profile

discuss aout cnc

• Wed Jun 17 23:36:24 2009:
  OPtion_Parameter_for_HMC_with_FANUC_OM_B_system Comment

  normally fanuc 0 pmc was burned in eprom.

  fanuc power mate 0 is keeped in sram with battary.

  so your battary was... be chinese version.you can use google--more

  --translation+guess.

  like me within guess to write english

  ...

• Tue Feb 26 12:06:35 2008:
  Zinser_500_CNC_RS_232_cable Comment

  I'm sorry the HTML can't display my drawing correctly.It deleted my text space. Mail me please! ydebin (at) yahoo... sorry the HTML can't display my drawing correctly.It deleted my text space. Mail me please! ydebin (at) yahoo (dot)com...

• Tue Feb 26 12:00:14 2008:
  Zinser_500_CNC_RS_232_cable Comment

  How to Make a CNC link cable:

  Suppose CNC has 25 pin socket. Pin 7 is 0V. Now first we will decide which pin is... needs 4-5-6-8-20 connection together. Some cases 4 5 6 8 20 has not any connection as Siemens 810, 820 etc.

  ...

• Tue Feb 26 11:28:57 2008:
  DNC_Direct_Numerical_Control Comment

  The cheap way is that you can buy a multiport(rs232) card. And multi run the same dnc software according your cnc... or VC you can use DDE or multi thread to write a program . Some new software plateform can support another good ways....

• Tue Feb 26 11:00:51 2008:
  Dnc_problem_for_Mitsubishi_Meldas_520AM Comment

  The protocol of hardware and software are the same result.

  As you know when cnc trans a xoff(hex 13) computer has to... change RTS's output voltage level to notice cnc transfer continually. I'm afraid my poor english.Any question can mail....

• Tue Feb 26 09:28:45 2008:
  Remote_connections Comment

  I think very currently protocol is... think very currently protocol is 802.11b...

• Tue Feb 26 09:15:23 2008:
  memory_low Comment

  You can connect a computer and cnc MODE switch turn on DNC or TAPE.

  And then push CYCLC START. It's OK!... can connect a computer and cnc MODE switch turn on DNC or TAPE.

  And then push CYCLC START. It's OK!

  ...

• Tue Feb 26 09:03:16 2008:
  DR_SIGNAL_OFF_alarm Comment

  1.Do you used hardware protocol or software protocol

  2.protocol and cable have to compatible.

  3.software protocol... ok fanuc system will flash LSK or EDIT as like as cnc system is reading and cnc no alarm.

  Sorry my poor english!

  ...

• Tue Feb 26 08:26:39 2008:
  dnc_problem Comment

  First we'd better to how many baudrate and how many feedrate . Normally the problem is caused by rs232 transfering... different baudrate. But market DNC software has not click off display function( it's not turn off power of crt)

  ...