Mitsman profile

Member name: Mitsman
From: Mitsubishi HQ, USA
Photos: Mitsman has not uploaded any photos
Joined: Mon Aug 6 18:04:24 2007
Profile updated: Mon Aug 6 18:04:24 2007

Contact: [please login to contact this member]
Mitsman has posted 0 messages and replied to 12 messages.

• Mon Sep 10 14:47:02 2007:
  530_controller Comment

  Goto :

  http://www.meau.com then go to the

  Downloads area - M500 control - instructions.

  I would post the link... go to the

  Downloads area - M500 control - instructions.

  I would post the link but this site will not allow it....

• Mon Sep 10 14:41:03 2007:
  Setting_up_Meldas_320m_v_control_for_dnc Comment

  Try 2 stop bits. Make sure NC is ready before sending from PC. Usually when you can send and not receive it is a cable... bits. Make sure NC is ready before sending from PC. Usually when you can send and not receive it is a cable problem....

• Mon Aug 6 18:55:01 2007:
  mitsubishi_lathe_w_m_nap Comment

  We can help you with the G-code part if it has a Mits... can help you with the G-code part if it has a Mits control.

  ...

• Mon Aug 6 18:43:27 2007:
  HOW_TO_RESTART_IN_THE_MIDDLE_OF_A_PROGRAM Comment

  Put an N-number at the line that you wish to start the machine at, if it already doesn't have one. On the search page... in the O( ) area, oput the N-number into the next set of data blocks and then hit input :

  O( ) N(120) ( ) INPUT

  ...

• Mon Aug 6 18:39:54 2007:
  meldas_2_error_message Comment

  Error 35 CMP-CMD ERR (arc) cutter compensation, tool length offset or tool position offset command has been programed... to turn on G41, G42 or G43 when G2 or G3 are modal. Make sure that G1 or G0 are modal when turning on G41, G42 or G43....

• Mon Aug 6 18:35:03 2007:
  ALARM_E06_NO_ESP Comment

  E06 means that you do not have the option for the function you are trying to run or turn... means that you do not have the option for the function you are trying to run or turn on....

• Mon Aug 6 18:32:13 2007:
  INSTRUCTION_MANUAL Comment

  Did you want operation or... you want operation or programming?...

• Mon Aug 6 18:30:45 2007:
  Meldas_320_Pitch_Error_compensation Comment

  Instructions start on page... start on page 322....

• Mon Aug 6 18:20:24 2007:
  Meldas_50m Comment

  Press Tool/Param hard key. Push Setup soft key. Set Parameter #1043 to a... Tool/Param hard key. Push Setup soft key. Set Parameter #1043 to a 1....

• Mon Aug 6 18:10:00 2007:
  G71_for_fanuc Comment

  G71 is the same cycle for Mits. Maybe you need to have the pocket machining parameter on. Or you do not have the fixed... Maybe you need to have the pocket machining parameter on. Or you do not have the fixed cycle option for this machine....

• Mon Aug 6 18:07:56 2007:
  dnc_software Comment

  Need model of control. Are you looking for Auto corner... model of control. Are you looking for Auto corner override?...

• Mon Aug 6 18:06:47 2007:
  wiring_diagrams_for_mitsubishi_m_v70d Comment

  Connection manual for a... manual for a M70...