Member name: Marcus Clayton
From: Melbourne Australia
Photos: Marcus Clayton has not uploaded any photos
Joined: Tue Jun 3 01:05:48 2008
Profile updated: Tue Jun 3 01:05:48 2008
Contact: [please login to contact this member]
Marcus Clayton has posted 0 messages and replied to 4 messages.
|
| List of 100 most recent messages and comments- Tue Jun 3 01:45:54 2008:
Mitsubisi_520MR CommentY29F is an output from the controller. If you go to the ladder, search for output Y29F, there will be input conditions,... will have to check in wiring diagram as to what it does. Likely to be an interlock though, or something related to it.... - Tue Jun 3 01:29:28 2008:
dnc_problem CommentI agree. Later models have bigger buffer and look ahead functions to smooth out machining. Does your post use multiple... data to do a curve is much better than sending thousands.As I said more powerful, late models can cope much better.... - Tue Jun 3 01:23:23 2008:
meldas Commentpretty good control. What is the... good control. What is the problem?... - Tue Jun 3 01:13:12 2008:
S01_Servo_Alarm_PR CommentS01 will have a code (up to 4 digits) and then an axis after it.example S01 003A X means overcurrent alarm on X... In the above case the most common cause is a bad ballscrew bearing or swarf build up causing an overload in the motor...
|
For the full benefit of The CNC Forum website please register and login. You can upload your photos and interact with other users better.
Note: once you register your email address with The CNC Forum it is used across our whole network of forums and blogs. You can create seperate profiles for each forum or blog, but use the same login.
|